| |
Vibration Analysis
| Monitek's Approach to Vibration Analysis (Roll over the images to find out more) |
| Machine Monitoring
Using sensitive equipment, Monitek's Condition Monitoring Specialist will take a number of vibration recordings from the machine.....
|
 |
| Analysis
Vibration recordings taken during the monitoring phase are analysed using Monitek's proprietry software.....
|
 |
| Diagnosis
Based on the Specialist's maintenance experience and equipment knowledge, a fault can be recognized and immediate recommendations provided....
|
 |
|
 |
|
Analysis
Data is analyzed using Monitek's proprietary software!The software used by Monitek has been specifically designed to allow spectral comparison, waterfall plots, cepstrum, figure of merit, side band index, RMS plots, order analysis, and time synchronous averaging.
|
 |
|
Diagnosis
Each machine fault has a specific vibration signature. Whether it be a bearing defect, gear wear, or a bent shaft, Monitek's Specialists can recognize the vibration signature.
Component degradation can be monitored! Using Monitek's software the Specialist can plot the component history, monitor degradation and advise the client accordingly.
Monitek's Condition Monitoring Specialists have a wide range of Maintenance Experience. Each Specialist brings significant maintenance experience to Monitek, and is used by the Specialist to prepare maintenance recommendations arising from the diagnosis.
|
 |
|
Machine Monitoring
Monitoring is performed during the machines production cycle. As the machine is on-load and under dynamic stress, an accurate analysis of machine conditions and faults can be provided to the client.
"..it's like the machine is operating in Monitek's office!" Monitek's instrumentation records the machine vibration in real-time allowing maximum flexibility during the analysis phase.
Measures the condition of gears, bearings, shafts, impellers, AC, and DC motors WITHOUT stripping them apart!! Monitek's instrumentation can accurately record vibration signatures for each of these components, even when they are part of the same machine!
|
It's no problem for Monitek!
|
|